Order CLS timber for delivery in Bexhill-on-Sea

Which CLS timber can you order in Bexhill-on-Sea?

• 38 × 63 mm CLSFor non-loadbearing partitions and boxing in.
• Graded CLSC16 or C24 graded CLS for loadbearing studwork where specified.
• Noggins and head platesCut from the same stock.
• 38 × 89 mm CLSFor taller partitions, more insulation depth or heavier boards.
• FixingsScrews, nails and frame fixings to suit.

Getting CLS timber onto your Bexhill-on-Sea site

CLS travels in bundles alongside plasterboard and is easy to hand off at the kerb. Bexhill-on-Sea is inside our standard mainland delivery area.

• On busy streets in Bexhill-on-Sea, a parking suspension or a quiet time slot can make offloading safer, so tell us about local restrictions you know of.
• Give us the full postcode for the drop point; deliveries around TN40 are priced to the exact address.
• Deliveries are to the kerb, drive or within crane reach; ask if materials need to go further.

Getting the right CLS timber

Loadbearing walls

If the wall carries load it needs graded timber to a design. Plain CLS is not automatically structural.

Stud spacing

Studs are usually set at 400 mm or 600 mm centres to suit 1200 mm wide plasterboard.

Quantities: a worked example

A 4.2 m partition 2.4 m high at 400 mm centres takes 12 CLS studs, 8.4 m of head and sole plate and a row of noggins, then boarding on both sides. Work out the boards too

Questions about CLS timber delivery in Bexhill-on-Sea

Is CLS timber treated?

CLS is kiln dried rather than treated as standard, because it is meant for dry internal use. Treated CLS is available if you need it.

Can you deliver CLS timber to a site with restricted access in Bexhill-on-Sea?

Usually, yes. Tell us about the access when you ask for a price and we will plan the vehicle and offload, or say if a smaller vehicle is needed.

Is there a minimum order for delivery to Bexhill-on-Sea?

There is no fixed minimum. For very small orders we will tell you honestly if the delivery cost outweighs the materials, so you can decide.

How many studs do I need?

Divide the wall length by the stud spacing (400 or 600 mm), add one, then add plates and noggins. Our plasterboard calculator gives the boards for the same wall.