CLS Studwork Timber for Ystalyfera, delivered to site

Our CLS timber range for Ystalyfera jobs

• 38 × 89 mm CLSFor taller partitions, more insulation depth or heavier boards.
• Noggins and head platesCut from the same stock.
• FixingsScrews, nails and frame fixings to suit.
• 38 × 63 mm CLSFor non-loadbearing partitions and boxing in.
• Graded CLSC16 or C24 graded CLS for loadbearing studwork where specified.

Sizing your order

A 5.4 m partition 2.4 m high at 400 mm centres takes 15 CLS studs, 10.8 m of head and sole plate and a row of noggins, then boarding on both sides. Work out the boards too

Before you order CLS timber

Stud spacing

Studs are usually set at 400 mm or 600 mm centres to suit 1200 mm wide plasterboard.

Which size?

38 × 63 mm suits most partitions up to standard ceiling heights. 38 × 89 mm gives stiffer, taller walls and more room for insulation.

Before your Ystalyfera delivery arrives

CLS travels in bundles alongside plasterboard and is easy to hand off at the kerb. Ystalyfera is inside our standard mainland delivery area.

• Weight limits on bridges or private roads near the site matter for larger lorries, so mention any you know of.
• On busy streets in Ystalyfera, a parking suspension or a quiet time slot can make offloading safer, so tell us about local restrictions you know of.
• Deliveries are to the kerb, drive or within crane reach; ask if materials need to go further.

CLS Studwork Timber questions

Is there a minimum order for delivery to Ystalyfera?

There is no fixed minimum. For very small orders we will tell you honestly if the delivery cost outweighs the materials, so you can decide.

Can CLS be used for loadbearing walls?

Only if it is strength graded and the wall is designed for the load. Ask for graded CLS if your design calls for it.

Can you deliver CLS timber to a site with restricted access in Ystalyfera?

Usually, yes. Tell us about the access when you ask for a price and we will plan the vehicle and offload, or say if a smaller vehicle is needed.

How many studs do I need?

Divide the wall length by the stud spacing (400 or 600 mm), add one, then add plates and noggins. Our plasterboard calculator gives the boards for the same wall.