CLS Studwork Timber delivered to Watford

Our CLS timber range for Watford jobs

• 38 × 63 mm CLSFor non-loadbearing partitions and boxing in.
• Graded CLSC16 or C24 graded CLS for loadbearing studwork where specified.
• 38 × 89 mm CLSFor taller partitions, more insulation depth or heavier boards.
• Noggins and head platesCut from the same stock.
• FixingsScrews, nails and frame fixings to suit.

Estimating your CLS timber

A 3.6 m partition 2.4 m high at 400 mm centres takes 10 CLS studs, 7.2 m of head and sole plate and a row of noggins, then boarding on both sides. Work out the boards too

CLS Studwork Timber: choosing well

Which size?

38 × 63 mm suits most partitions up to standard ceiling heights. 38 × 89 mm gives stiffer, taller walls and more room for insulation.

Stud spacing

Studs are usually set at 400 mm or 600 mm centres to suit 1200 mm wide plasterboard.

Before your Watford delivery arrives

CLS travels in bundles alongside plasterboard and is easy to hand off at the kerb. Watford is inside our standard mainland delivery area.

• Give us the full postcode for the drop point; deliveries around WD17 are priced to the exact address.
• If the drop point is block paving or soft ground, say so; heavy pallets and bulk bags can mark or sink.
• Mention any overhead cables, low branches or narrow gateways, because they decide whether a crane offload is possible.

Common questions from Watford

Is CLS timber treated?

CLS is kiln dried rather than treated as standard, because it is meant for dry internal use. Treated CLS is available if you need it.

Can you deliver CLS timber to a site with restricted access in Watford?

Usually, yes. Tell us about the access when you ask for a price and we will plan the vehicle and offload, or say if a smaller vehicle is needed.

Is there a minimum order for delivery to Watford?

There is no fixed minimum. For very small orders we will tell you honestly if the delivery cost outweighs the materials, so you can decide.

How many studs do I need?

Divide the wall length by the stud spacing (400 or 600 mm), add one, then add plates and noggins. Our plasterboard calculator gives the boards for the same wall.