Order PIR insulation boards for delivery in Ross-on-Wye

Which PIR insulation boards can you order in Ross-on-Wye?

• Thermal laminate boardsPIR bonded to plasterboard.
• Flat roof boardsBoards for warm flat roof build-ups.
• General-purpose PIR boards2400 × 1200 mm foil-faced boards for floors, walls and roofs.
• Cavity wall boardsBoards sized for partial-fill cavity insulation.
• Foil tape and fixingsTo seal joints and fix boards.

Delivery to Ross-on-Wye: what helps

Boards are light but bulky; they travel in wrapped packs and should be stored flat and dry. Ross-on-Wye is inside our standard mainland delivery area.

• If the drop point is block paving or soft ground, say so; heavy pallets and bulk bags can mark or sink.
• Mention any overhead cables, low branches or narrow gateways, because they decide whether a crane offload is possible.
• Deliveries are to the kerb, drive or within crane reach; ask if materials need to go further.

How much will you need?

Insulating 24 m² of rafters, floor or wall takes 9 boards of 2400 × 1200 mm including offcuts. The thickness depends on the U-value you need, so check it before you order. Try the insulation calculator

PIR Insulation Boards: choosing well

Thickness for the U-value

The thickness you need depends on the U-value the building regulations require and the rest of the build-up. Manufacturers publish U-value tables; your designer or building control will confirm.

Sealing joints

Tape the joints with foil tape so the foil layer works as a continuous vapour control layer where the design relies on it.

In England, building work is checked against the Approved Documents, for example Part A for structure and Part L for energy efficiency, through your council's building control team or a registered building control approver.

Your questions answered

Can you deliver PIR insulation boards to a site with restricted access in Ross-on-Wye?

Usually, yes. Tell us about the access when you ask for a price and we will plan the vehicle and offload, or say if a smaller vehicle is needed.

Is there a minimum order for delivery to Ross-on-Wye?

There is no fixed minimum. For very small orders we will tell you honestly if the delivery cost outweighs the materials, so you can decide.

How many PIR boards do I need?

Divide the area by 2.88 m² (one 2400 × 1200 board) and add about 5 to 10 percent for cutting.

What is the foil for?

The foil facing reflects heat, protects the foam and, when joints are taped, can act as a vapour control layer.