PIR Insulation Boards delivery in Pimlico

Our PIR insulation boards range for Pimlico jobs

• Foil tape and fixingsTo seal joints and fix boards.
• Cavity wall boardsBoards sized for partial-fill cavity insulation.
• Thermal laminate boardsPIR bonded to plasterboard.
• Flat roof boardsBoards for warm flat roof build-ups.
• General-purpose PIR boards2400 × 1200 mm foil-faced boards for floors, walls and roofs.

Before you order PIR insulation boards

Thickness for the U-value

The thickness you need depends on the U-value the building regulations require and the rest of the build-up. Manufacturers publish U-value tables; your designer or building control will confirm.

Sealing joints

Tape the joints with foil tape so the foil layer works as a continuous vapour control layer where the design relies on it.

In England, building work is checked against the Approved Documents, for example Part A for structure and Part L for energy efficiency, through your council's building control team or a registered building control approver.

Quantities: a worked example

Insulating 12 m² of rafters, floor or wall takes 5 boards of 2400 × 1200 mm including offcuts. The thickness depends on the U-value you need, so check it before you order. Try the insulation calculator

Delivery to Pimlico: what helps

Boards are light but bulky; they travel in wrapped packs and should be stored flat and dry. Pimlico is inside our standard mainland delivery area.

• If the drop point is block paving or soft ground, say so; heavy pallets and bulk bags can mark or sink.
• Mention any overhead cables, low branches or narrow gateways, because they decide whether a crane offload is possible.
• Clear a level area for pallets, ideally on boards, so materials stay out of standing water.

Questions about PIR insulation boards delivery in Pimlico

Do you deliver PIR insulation boards to Pimlico?

Yes. We deliver across Pimlico, including SW1, SW8. Pimlico is inside our standard mainland delivery area. Send your list or call 0800 088 6341 and we will price it delivered to your postcode.

Can you deliver PIR insulation boards to a site with restricted access in Pimlico?

Usually, yes. Tell us about the access when you ask for a price and we will plan the vehicle and offload, or say if a smaller vehicle is needed.

How thick should PIR insulation be?

It depends on where it goes and the U-value required. Pitched roofs often need 100 mm or more between and under rafters; floors and walls vary. Use the maker's U-value tables or ask your designer.

What is the foil for?

The foil facing reflects heat, protects the foam and, when joints are taped, can act as a vapour control layer.