Damp Proofing & Membranes delivery in Stourbridge

Which damp proofing can you order in Stourbridge?

• Radon barriersGas-resistant membranes for areas that need radon protection.
• DPM sheetingHeavy-gauge polythene membrane under concrete floors.
• DPC rollsPolymer and bitumen damp-proof course in standard wall widths.
• Liquid DPM and tankingCoatings for screeds and below-ground walls.
• Cavity trays and stop endsTo direct water out of the cavity over openings.

Delivering damp proofing in Stourbridge

Rolls are light enough to travel with a mixed load and are handed off at the kerb. Stourbridge is inside our standard mainland delivery area.

• For a phased build we can split the order so materials arrive as each stage starts, which keeps the site clear.
• If the drop point is block paving or soft ground, say so; heavy pallets and bulk bags can mark or sink.
• Deliveries are to the kerb, drive or within crane reach; ask if materials need to go further.

Choosing damp proofing

Laps and joints

DPM and DPC need generous laps and sealed joints; follow the manufacturer's guidance.

DPC width

Match the DPC width to the wall leaf so it runs the full width of the masonry.

In England, building work is checked against the Approved Documents, for example Part A for structure and Part L for energy efficiency, through your council's building control team or a registered building control approver.

Sizing your order

An extension in Stourbridge with 16 m of cavity wall needs DPC in both leaves: about 2 rolls in 30 m lengths once laps are allowed for. A 40 m² floor slab needs about 46 m² of DPM including laps, which is 1 roll of 4 × 25 m sheeting.

Ordering damp proofing for Stourbridge: FAQs

Is there a minimum order for delivery to Stourbridge?

There is no fixed minimum. For very small orders we will tell you honestly if the delivery cost outweighs the materials, so you can decide.

Can you deliver damp proofing to a site with restricted access in Stourbridge?

Usually, yes. Tell us about the access when you ask for a price and we will plan the vehicle and offload, or say if a smaller vehicle is needed.

How thick should a DPM be?

1200-gauge polythene, around 300 microns, is a common specification for floor slabs. Your design may call for something different.

Where does the DPC go?

Usually at least 150 mm above outside ground level, linked to the floor DPM.