Damp Proofing & Membranes for Crieff, delivered to site

Choosing from our damp proofing range

• Liquid DPM and tankingCoatings for screeds and below-ground walls.
• DPC rollsPolymer and bitumen damp-proof course in standard wall widths.
• DPM sheetingHeavy-gauge polythene membrane under concrete floors.
• Radon barriersGas-resistant membranes for areas that need radon protection.
• Weep ventsFor drainage and ventilation at the base of cavities and over trays.

Delivery to Crieff: what helps

Rolls are light enough to travel with a mixed load and are handed off at the kerb. Crieff is inside our standard mainland delivery area.

• On busy streets in Crieff, a parking suspension or a quiet time slot can make offloading safer, so tell us about local restrictions you know of.
• Deliveries are to the kerb, drive or within crane reach; ask if materials need to go further.
• Clear a level area for pallets, ideally on boards, so materials stay out of standing water.

Before you order damp proofing

Laps and joints

DPM and DPC need generous laps and sealed joints; follow the manufacturer's guidance.

Is radon protection needed?

Parts of the UK need radon protection in new buildings and extensions. UKHSA radon maps show the areas; the council's building standards service will tell you what applies.

In Scotland most building work needs a building warrant from the local authority, assessed against the Building Standards Technical Handbooks.

How much will you need?

An extension in Crieff with 16 m of cavity wall needs DPC in both leaves: about 2 rolls in 30 m lengths once laps are allowed for. A 30 m² floor slab needs about 34.5 m² of DPM including laps, which is 1 roll of 4 × 25 m sheeting.

Common questions from Crieff

Do I need a radon barrier?

It depends on where you are. In radon-affected areas building standards require radon protection in new buildings and extensions.

Can you deliver damp proofing to a site with restricted access in Crieff?

Usually, yes. Tell us about the access when you ask for a price and we will plan the vehicle and offload, or say if a smaller vehicle is needed.

How thick should a DPM be?

1200-gauge polythene, around 300 microns, is a common specification for floor slabs. Your design may call for something different.

Is there a minimum order for delivery to Crieff?

There is no fixed minimum. For very small orders we will tell you honestly if the delivery cost outweighs the materials, so you can decide.